Nortel North American DMS-100 Instruction Manual page 538

TOPS MP Operator complaint (standalone/integrated)
Example of a TAMI response
CARD STATUS CARD SUBSTATUS APPLID LINK 0 STATUS
InSv
3
Example of a TAMI response
CARD STATUS CARD SUBSTATUS APPLID LINK 0 STATUS
ManB
4
At the TPC
5
6
DMS-100 Family NA100 Trouble Locating and Clearing Procedures Volume 2 of 2 LET0015 and up
Trouble locating and clearing procedures (continued)
Clearing DA access trouble
Press the Enter key.
where
1
is the link number
Comact
To busy the HSDA card, type:
>1
Press the Enter key.
Comact
To return to the TAMI main menu, press the PF3 key one time.
To test the HSDA card, load the diskettes into the disk drive of the TPC. Insert
the Diagnostic Boot diskette into the disk drive of the TPC and push the lever
to lock the diskette in place.
Note: Make sure the edge that has notches is at the top and the label
faces the hard disk.
CAUTION
Service interruption
Use of the reset switch takes all MP positions associated with
the TPC out of service. Make sure you return to service all
MP positions associated with this TPC at the end of the
procedure.
To set the TPC again, move the switch on the SBC card in slot 6 to the down
position. Return the switch to the up position.
HSDA3386 ManB
HSDA3386 ManB
1-517
(continued)
LINK 0 STATUS
ManB
LINK 0 STATUS
ManB