Nortel North American DMS-100 Instruction Manual page 513

1-492 Trouble locating and clearing procedures (continued)
TOPS MP Operator complaint (standalone)
Clearing position failure - cannot RTS position
14
15
Example of a TAMI response
16
17
At the affected MP position
18
19
297-8021-544 Standard 14.02 May 2001
If the VDU displays
any other message
Perform the common procedure Removing an MP position from service
(standalone) .
To access the Diagnostic screen from the TAMI main menu, type:
>5
and press the Enter key.
Enter TPC Diagnostics command:
To test the MP position VDU, type:
>POSDIAG n SCREEN
and press the Enter key.
where:
n
is the MP position number (0, 1, 2, or 3)
If screen diagnostics test
passes
fails
To exit the Diagnostics screen, type:
>QUIT
and press the Enter key.
Replace the MP VDU. Go to Card Replacement Procedures and return to the
next step.
Perform the common procedure Placing an MP position in service
(standalone) .
(continued)
Do
Refer to the correct locating and
clearing trouble procedure for
the indicated trouble.
Do
step 22
step 17