Nortel North American DMS-100 Instruction Manual page 511

1-490 Trouble locating and clearing procedures (continued)
TOPS MP Operator complaint (standalone)
Clearing position failure - cannot RTS position
At the affected MP position
9
Power switch
10
11
12
297-8021-544 Standard 14.02 May 2001
To turn the MP position on and off, move the power switch on the MP VDU.
Move the power switch on the MP VDU to the off (0) position and then to the
on (|) position. Refer to the figure below.
Rear view MP position
|
Check the four icon indicators on the initializing screen of the MP VDU.
If initializing screen indicators
have checkmarks ( )
are not correct
Check the keyboard indicator.
If the keyboard indicator is
a checkmark ( )
not a checkmark
Make sure the keyboard cable plugs in the base controller.
(continued)
0
Do
step 26
step 11
Do
step 14
step 12
AC connector
Base
controller