Nortel North American DMS-100 Instruction Manual page 412

Softkey information does not download to the ADSI set
Softkey information does not download to the ADSI set
At the MAP terminal:
1
2
3
4
5
6
7
DMS-100 Family NA100 Trouble Locating and Clearing Procedures Volume 2 of 2 LET0015 and up
Trouble locating and clearing procedures (continued)
To access the PM level of the MAP display, type
>MAPCI;MTC;PM
and press Enter.
To display all the ISTb PMs, type
>POST ISTB
and press Enter.
To check for fault indicators, type
>QUERYPM FLT
and press Enter.
If response
is CLASS MODEM RESOURCE CARD NT6X78
OUT OF SERVICE
CMR DATA MISMATCH WITH CC
CMR LOAD MISMATCH WITH INVENTORY
TABLE
is other than listed here
Check the card list for the CMR card.
The following card list is a standard message that refers to a CMR card that
is out of service.
QUERYPM FLT
CLASS MODEM RESOURCE CARD NT6X78
OUT OF SERVICE
Replace the Cards in the Card List
and applicable Paddleboards (i.e. 6X12) :
Site Flr RPos Bay_id
HOST 01 D02 LGE
Check the card list for the CMR card.
If CMR card
is on card list
is not on card list
Use the Card Replacement Procedures manual to replace the CMR card.
Perform PM maintenance.
Shf Description
00 18 LGC : 000
Do
step 6
step 7
1-397
(continued)
Do
step 4
step 8
step 11
step 18
Slot EqPEC
13 6X78