Nortel North American DMS-100 Instruction Manual page 341

1-326 Trouble locating and clearing procedures (continued)
Running a C7BERT
45
46
47
48
297-8021-544 Standard 14.02 May 2001
(continued)
Give the results to the persons responsible for the next level of support.
If
the link stops on an NT9X77AA,
NT9X78BA/CA/DA/DB, or NTEX26AA card, and
you just ran a peripheral module (PM) local or re-
mote loopback. If instructions required you to return
the link to service
the link stops on an NT9X77AA,
NT9X78BA/CA/DA/DB, or NTEX26AA card, and
you just ran a PM local or remote loopback. If in-
structions required you to perform more tests
the link does not stop on an NT9X77AA,
NT9X78BA/CA/DA/DB, or NTEX26AA card
other than listed here
Remove the manual loopback across network elements.
Your next step depends on the instructions received from your next level of
support.
If
instructions required you to re-
turn the link to service
instructions required you to per-
form more tests
other than listed here
To deactivate a local loopback, type
>PMLOOP LOCOFF
and press Enter.
where
link_no
is the number of the link you tested in step 18
If the response
is pmloop off 1
Link 1: Loopback Lo-
cal off completed
is other than listed here
Do
step 55
step 24
step 110
link_no
Do
step 55
step 66
Do
step 48
or 49
step 48
or 49
step 46
step 110