Nortel North American DMS-100 Instruction Manual page 369

1-354 Trouble locating and clearing procedures (continued)
Running a C7BERT for high-speed links
34
35
36
297-8021-544 Standard 14.02 May 2001
If the equipment type is DMS, personnel at the far-end can determine the
signaling terminal status as follows:
Type PM and press the Enter key to access the PM level of the MAP
•
display.
Type POST HLIU dliu_no and press the Enter key to post the HLIU.
•
• Type LOOPBK S and press the Enter key to display the terminal status.
Users of equipment that is not DMS should contact their next level of support
to obtain the procedures for their equipment.
To activate the far-end DS-1 ESF loopback from your end, type
>CARLOOP START
and press the Enter key.
where
link_no
is the number of the link you want to test (0 to 15)
loopback_type
indicates if the loopback is line (R) or payload (P)
Example input:
>CARLOOP START
Your next step depends on the response.
If the response is
Link nn: DS-1 EFT Loop ON
complete
Carrier line loopback at far-end
paddleboard
Link nn: Failed - C7BERT al-
ready active on this link
Link 1: Failed - Far-end DS-1
ESF already active on this link
Link nn: Failed - Has not gone
into loopback.
anything else
To stop the existing HSL C7BERT, type
>STOP link_no
and press the Enter key.
where
link_no
is the number of the link you entered in step 34
(continued)
link_no loopback_type
1 R
Do
step 39
step 36
step 37
step 78
step 78