Nortel North American DMS-100 Instruction Manual page 499

1-478 Trouble locating and clearing procedures (continued)
TOPS MP Operator complaint (standalone)
Clearing position failure - cannot reboot TPC
4
5
6
Power
switch
297-8021-544 Standard 14.02 May 2001
Replace the power card in slot 25. Refer to Card Replacement Procedures
and return to this step.
If
autobooting... continues to ap-
pear
the TPC reboots
any other message appears
Replace the new power card with the power card removed in step 4. Refer to
Card Replacement Procedures and return to step 6.
Determine if the hard disk drive is on.
SBC reset switch
1–3 6
Disk drives and switch locations on the TPC
If the hard disk drive power
switch is
set to the on position
set to the off position
(continued)
Do
step 5
step 25
Refer to the correct locating and
clear trouble procedure for the
indicated trouble.
Fixed disk drive
17–19 21–23 25–27
Do
step 7
step 9
Power
switch