Nortel North American DMS-100 Instruction Manual page 497

1-476 Trouble locating and clearing procedures (continued)
TOPS MP Operator complaint (standalone)
Clearing position failure - cannot reboot TPC
2
3
297-8021-544 Standard 14.02 May 2001
If the error message is
1 meg of memory
any other message
To set the TPC again, lower and lift the single-board computer (SBC) reset
switch.
SBC reset switch
1–3
6
Disk drives and switch locations on the TPC
If
the TPC reboots
the VDU displays an asterisk (*) step 24
the VDU displays any other
message
To determine if the TPC has a power outage, check the frame fail light on the
frame supervisory panel (FSP).
(continued)
Do
step 20
Refer to the correct locating and
clear trouble procedure for the
indicated trouble.
25–27
17–19 21–23
Do
step 25
Refer to the correct locating and
clear trouble procedure for the
indicated trouble.
Power
switch