Nortel North American DMS-100 Instruction Manual page 392

Scheduling ISUP trunk audits
At the MAP terminal
1
2
3
4
DMS-100 Family NA100 Trouble Locating and Clearing Procedures Volume 2 of 2 LET0015 and up
Trouble locating and clearing procedures (continued)
Scheduling ISUP trunk audits
CAUTION
Possible loss of service
Ensure table TRKSGRP is datafilled to include the ISUP
trunks on which you want to perform the audit before you run
the ISUP audit. For more information on table TRKSGRP,
refer to the data schema section of the Translations Guide.
To access table OFCENG, type
>TABLE OFCENG
and press Enter.
Example of a MAP response:
TABLE: OFCENG
Note: Access to table OFCENG is restricted. If access is denied, contact
your next level of support.
To position on office parameter CIRCUIT_QUERY_AUDIT_START_TIME,
type
>POSITION CIRCUIT_QUERY_AUDIT_START_TIME
and press Enter.
Example of a MAP response:
CIRCUIT_QUERY_AUDIT_START_TIME
To display the tuple with headers, type
>LIST
and press Enter.
Example of a MAP response:
PARMNAME
CIRCUIT_QUERY_AUDIT_START_TIME
Note: In the MAP example, 2 0 is the current ISUP trunk audit start time
in hours (0 to 23) and minutes (0 to 59).
Decide if you want to change the ISUP trunk audit start time.
If the ISUP trunk audit start time
does not require change
2 0
PARMVAL
2 0
Do
step 8
1-377
(continued)