Nortel North American DMS-100 Instruction Manual page 514

Clearing position failure - cannot RTS position
At the TAMI
20
At the affected MP position
21
At the TAMI
22
23
At the TPC
24
At the TAMI
25
26
27
DMS-100 Family NA100 Trouble Locating and Clearing Procedures Volume 2 of 2 LET0015 and up
Trouble locating and clearing procedures (continued)
TOPS MP Operator complaint (standalone)
Check the Position Status/Control menu.
If the VDU displays
InSv
SysB with new MP VDU
any other message
Replace the new MP VDU with the original MP VDU removed in step 18. Go
to Card Replacement Procedures and return to step 24.
To exit the Diagnostics screen, type:
>QUIT
and press the Enter key.
Perform the common procedure Placing an MP position in service
(standalone) .
Replace the RAM card in slot 7. Go to Card Replacement Procedures and
return to the next step.
Check the Position Status/Control menu.
If the VDU displays
InSv
SysB
any other message
Perform the common procedure Removing an MP position from service
(standalone) .
Press the PF3 key to exit the Position Status/Control menu and enter the
TAMI main menu. To access the Diagnostics screen, type:
>5
Do
step 45
step 21
Refer to the correct clearing and
locating trouble procedure for
the indicated trouble.
Do
step 45
step 26
Refer to the correct locating and
clearing trouble procedure for
the indicated trouble.
1-493
(continued)