Nortel North American DMS-100 Instruction Manual page 279

1-264 Trouble locating and clearing procedures (continued)
Reseating a line card
5
6
7
8
297-8021-544 Standard 14.02 May 2001
(continued)
DANGER
Risk of personal injury
The large, flat rectangular component mounted on the front
edge can be very hot. To avoid burns to your fingers, use the
insertion and withdrawal tool. Use the tool to remove and
reseat the card as illustrated in step 6.
Locate the card you want to remove (it can be either a 3-in or a 6-in card).
Clamp the insertion and withdrawal tool to the front edge of the card, as
illustrated below. Carefully remove the card from the connector pins.
Insertion/withdrawal
tool
Align the card with the connector pins and carefully reseat the card.
Ensure the card sits in a secure position.