Nortel North American DMS-100 Instruction Manual page 256

Replacing an NTFX39 bulkhead splitter unit
8
9
10
11
12
13
DMS-100 Family NA100 Trouble Locating and Clearing Procedures Volume 2 of 2 LET0015 and up
Trouble locating and clearing procedures (continued)
To manually busy the port, type
>BSY
and press Enter.
where
port_no
is the port identification number
If the BSY command
passed
failed
Repeat step 8 until you manually busy all CONS ports.
The next action depends on any provisioned multiprotocol controller (MPC)
ports that are on the controller card.
If provisioned MPC ports
are present
are not present
To post a port for the MPC, type
>PORT port_no
and press Enter.
where
port_no
is the port identification number
Example of a IOM MAP display:
Port 9 Unit
User
Status
Determine the state of the port.
If the port state
is ManB
is OFFL
is other than listed here
To display status information on current MPC conversations, type
>QCONV
and press Enter.
Do
step 9
step 57
Do
step 11
step 18
0
SYSTEM PROTOCOL
Ready X2584
Do
step 17
step 55
step 13
1-241
(continued)
LINK
COMACT ENABLED