Nortel North American DMS-100 Instruction Manual page 339

1-324 Trouble locating and clearing procedures (continued)
Running a C7BERT
38
39
40
41
297-8021-544 Standard 14.02 May 2001
(continued)
Link 1: C7BERT query
Run Time
Tx Frames
Rx Frames
Rx Bit Errors:
Bit Err Rate : 1 x 10– 8
If the response
is a display of test statistics
is other than listed here
Determine the result of bit error injection.
Note: In the example in step 37, the number of bit errors received appears
to the right of Rx Bit Errors.
Subtract the result of the C7BERT recorded in step 35 from the result
obtained in step 38.
If the difference
is 6
is other than listed here
To determine if any requests existed for periodic reports, type
>REPORT link_no
and press Enter.
where
link_no
is the number of the link (0 to 15) that the C7BERT runs on
If the response
is Link nn: Report interval al-
ready set at: mm times per hour
is Link nn: Automatic query re-
porting is not active
is other than listed here
To clear the last report interval, type
>REPORT link_no
and press Enter.
where
: 1134 Err Free Secs:
: 32568 Rx Sync Errs :
: 32570 Rx Bad Frames:
6 Rx Bits
Do
step 38
step 66
Do
step 33
step 66
STATUS
Do
step 41
step 42
step 66
OFF
1133
0
1
: 66670792