Nortel North American DMS-100 Instruction Manual page 516

Clearing position failure - cannot RTS position
At the TAMI
33
34
35
36
Example of a TAMI response
Enter TPC Diagnostics command:
37
DMS-100 Family NA100 Trouble Locating and Clearing Procedures Volume 2 of 2 LET0015 and up
Trouble locating and clearing procedures (continued)
TOPS MP Operator complaint (standalone)
Examine the Position Status/Control menu.
If the VDU displays
InSv
SysB
any other message
Replace the new HSLI card with the original HSLI card removed in step 30.
Go to Card Replacement Procedures , and return to step 37.
Perform the common procedure Removing an MP position from service
(standalone) .
To exit and the Position Status/Control menu and enter the TAMI main menu,
press the PF3 key. To access the Diagnostics screen, type:
>5
and press the Enter key.
To run the terminal controller diagnostics (TCD) test, type:
>POSDIAG n TCD
and press the Enter key.
where:
n
is the MP number on the TPC (0,1, 2, or 3)
Note: You can only select ManB positions.
Do
step 45
step 35
Refer to the correct locating and
clearing trouble procedure for
the indicated trouble.
1-495
(continued)