Nortel North American DMS-100 Instruction Manual page 236

7
8
9
10
11
12
DMS-100 Family NA100 Trouble Locating and Clearing Procedures Volume 2 of 2 LET0015 and up
Trouble locating and clearing procedures (continued)
Insertion/withdrawal
tool
Place the removed card into an electrostatic discharge (ESD) protective
container.
Make sure the replacement card has the same PEC and PEC suffix as the
removed card.
Clamp the insertion and withdrawal tool to the front edge of the replacement
card, as shown in step 6. Align the card with the connector pins and carefully
insert the card.
Make sure the card sits in a secure position.
Carefully push the drawer back into the shelf until the thumb-latch button
locks.
The procedure is complete. Return to the main procedure that sent you to this
procedure and follow the directions.
Replacing a line card
1-221
(end)