Nortel North American DMS-100 Instruction Manual page 334

22
23
24
25
26
DMS-100 Family NA100 Trouble Locating and Clearing Procedures Volume 2 of 2 LET0015 and up
Trouble locating and clearing procedures (continued)
If the response
is other than listed here
PM loop functionality is not available on your switch.
If
you want to run a C7BERT
other than listed here
To stop the C7BERT that exists, type
>STOP link_no
and press Enter.
where
link_no
is the number of the link that you entered in PMLOOP command
Note: The STOP command overrides a preset stop time without warning.
If the response
is Link 1: C7BERT stopped
is other than listed here
Apply manual loopbacks to the network elements that you will test.
To determine if a set stop time exists, type
>SETSTOP link_no
and press Enter.
where
link_no
is the number of the link (0 to 15) that the C7BERT runs on
If the response
is Link nn: Stop time set at:
is time
is Link nn: No stop time has
been set
is other than listed here
To clear the stop time, type
>SETSTOP link_no
and press Enter.
Running a C7BERT
Do
step 66
Do
step 24
step 66
Do
repeat PMLOOP
step 66
STATUS
Do
step 26
step 27
step 66
CLEAR
1-319
(continued)