Nortel North American DMS-100 Instruction Manual page 345

1-330 Trouble locating and clearing procedures (continued)
Running a C7BERT
63
64
65
66
67
To run link fault sectionalization (LFS) the SOC option TEL0007 must have the RTU
set to "Y" and the state set to "on".
297-8021-544 Standard 14.02 May 2001
(continued)
Tell the person at the far-end office to activate the link. To activate the link
from your end, type
>ACT link_no
and press Enter.
where
link_no
is the number of the link you activated in step 56
If the ACT command
passed
failed
To return the link to service, type
>RTS link_no
and press Enter.
where
link_no
is the number of the link you activated in step 56
If the RTS command
passed
failed
To unhibit the link, type
>UINH link_no
and press Enter.
where
link_no
is the number of the link you activated in step 56
If the UINH command
passed
failed
For additional help, contact the next level of support.
Do
step 64
step 66
Do
step 65
step 66
Do
step 110
step 66
ATTENTION