Nortel North American DMS-100 Instruction Manual page 379

1-364 Trouble locating and clearing procedures (continued)
Running a C7BERT for high-speed links
70
71
72
73
74
75
76
297-8021-544 Standard 14.02 May 2001
and press the Enter key.
where
link_no
is the number of the link (0 to 15)
If the ACT command
passed
failed
Determine the synchronization state of the link.
Note: The synchronization state appears under the Sync Stat header of
the MAP display.
If the synchronization state is
Sync
anything else
Wait 8 min, then continue the procedure.
Determine the synchronization state of the link.
If the synchronization state is
SysB, and you have not asked
the far-end office to activate the
link
SysB, and you have asked the
far-end office to activate the link
Use office records to determine which far-end office connects to the linkset
posted in step 4.
Contact the far-end office. Tell the personnel there that you will reactivate the
link.
Tell personnel at the far-end office to activate the link.
To activate the link from your end, type
>ACT link_no
and press the Enter key.
where
link_no
is the number of the link you activated in step 69
If the ACT command
passed
(continued)
Do
step 70
step 78
Do
step 77
step 71
Do
step 74
step 73
Do
step 77