Nortel North American DMS-100 Instruction Manual page 532

Clearing voice communication path trouble
Example of a TAMI response
Performing ROM position Component Diagnostic...
Performing CPU position Component Diagnostic...
Performing Exceptions position Component Diagnostic...
Performing RAM position Component Diagnostic...
Performing HSLI Port position Component Diagnostic...
Performing UART position Component Diagnostic...
Performing Keyboard position Component Diagnostic...
Performing Telephony position Component Diagnostic...
At the affected MP position
16
At the MAP
17
18
19
DMS-100 Family NA100 Trouble Locating and Clearing Procedures Volume 2 of 2 LET0015 and up
Trouble locating and clearing procedures (continued)
TOPS MP Operator complaint (standalone)
If test
passes
fails
fails with base controller
replaced
Replace the base controller. Refer to Card Replacement Procedures and
return to step 15.
To return the CF3P busied in step 9 to service, type:
>POST G CF3P n
and press the Enter key.
where
n
is the CF3P busied in step 9
>RTS
and press the Enter key.
If the CF3P
returns to service
does not return to service
For additional help, contact the next level of support.
Perform the common procedure Placing an MP position in service
(standalone) .
Do
step 17
step 16
step 18
Do
step 19
step 18
1-511
(continued)