Avaya DEFINITY Server R Manual page 428

Adding or Removing Cabinet Hardware
!
FTP the new firmware image file
The following steps are generic to most FTP programs. Use your laptop/PC/UNIX
to complete this procedure.
1. Ensure that the new firmware image file is in the same directory where you
will launch the FTP session.
2. Enter ping source_ip_address to verify a communication link to the
source board.
3. Enter ftp source_ip_address.
4. Log into the source circuit pack with the same ftplogin and ftppassword
that you used in the
5. Enter bin.
This transfers files in binary format.
6. If you are downloading to a TN2501AP (VAL) circuit pack only, enter cd /.
This command moves you from the announcement directory (default for an
FTP session) to the root directory ("/"), where firmware and other files
reside.
7. Enter put filename.ext.
This command copies the new firmware image file to the destination
directory.
8. Enter dir.
Verify that the new firmware image file is on the circuit pack.
9. Enter quit.
This ends the FTP session.
7-12
Issue 5 October 2002
CAUTION:
Unless the Remove Image File After Successful Download
field is set to y, the ftplogin and ftppassword remain on the TN799DP
(C-LAN) and TN2501AP (VAL) circuit packs either until they are reset
or until you issue the disable filesystem board UUCSS command.
''Set up circuit pack's file system''
ftplogin is any temporary login ID for this FTP session (for example,
denver).
ftppassword is any ≥ 7-character temporary password for this FTP
session (for example, broncos).
section.
555-233-115