Avaya DEFINITY Server R Manual page 217

Remove Module Control Carrier(s)
2. Disconnect the "P1" and "P2" cables from the "A" carrier. See
3. Remove the fan trim plate by pulling it straight off.
4. Clean or replace the air filter (403326820) if necessary.
5. In front of the carrier, remove the 4 screws (top 2 first) holding the "A"
carrier to the cabinet frame. Use a long-handle screwdriver or 5/16-inch
socket with a 10-inch extension.
6. Behind the carrier, remove the 2 screws holding the "A" carrier's rear
connector panel to the cabinet frame.
7. Slide the carrier forward 1 to 2 inches. Be sure that no cables or wiring
harnesses are caught on the cabinet/carrier framework.
!
8. Remove the carrier by sliding it out the front of the cabinet.
Figure Notes
1. Rear of Control Carrier
2. P2 Connector
Figure 5-3. Location of P1 and P2 Connectors
555-233-115
CAUTION:
Cables and wiring harnesses can be damaged if they catch on the
framework and if too much pressure is applied in removing the carrier.
3. P1 Connector
Issue 5 October 2002
Figure 5-3.
5-25