Avaya DEFINITY Server R Manual page 502

Adding or Removing Cabinet Hardware
Figure Notes
1. LCD display
2. Reset button (recessed)
3. Red board status LED
Figure 7-15. TN802B IP Interface faceplate
NOTE:
To properly seat the circuit pack, push firmly on the front of the faceplate
until the latch reaches the bottom rail of the carrier. Then close the latch until
it is fully engaged.
1. Insert the TN802B IP Interface into the rightmost of the three slots you
reserved for it (see
When you plug in the TN802B IP Interface, the circuit pack starts to boot
and the LCD reads PC Boot then after about 3 to 4 minutes it changes to
IP TRK *, the default mode.
7-86
Issue 5 October 2002
1
2
3
4
5
fpdfmapd KLC 030899
4. PCMCIA card slot
5. Yellow PCMCIA disk-in-use LED
Figure 7-16).
555-233-115