Avaya DEFINITY Server R Manual page 337

Add a Control Carrier (Add Duplication)
Remove Port Carrier B
1. Behind the PPN, disconnect and remove the ICCB cable from between
carrier "B" and carrier "A." It will not be reused.
2. Disconnect 1 end of the TDM/LAN cable (between the "B" and "C" carriers)
from the "B" carrier (See
3. Disconnect 1 end of the TDM/LAN cable (between the "B" and "A" carriers)
from the "B" carrier (See
4. Disconnect 1 end of the 8 ground straps (between the "B" and "C" carriers)
from the "B" carrier (See
new "B" carrier.
5. Disconnect 1 end of the 8 ground straps (between the "B" and "A" carriers)
from the "B" carrier (See
new "B" carrier.
6. Disconnect the "P1" (small 9-pin) connector from the "B" carrier. Move the
cable into a position where it will not interfere with removing the carrier.
7. Behind the "B" carrier, remove the 2 screws holding the "B" carrier's rear
connector panel to the cabinet frame. These are frame ground screws.
8. In front of "B" carrier, remove the 4 screws (top 2 first) holding the "B"
carrier to the cabinet frame. Use a long-handle screwdriver or 5/16-inch
socket with a 10-inch extension.
9. Slide the carrier forward 1 to 2 inches; then, from the back, be sure that no
cables or wiring harnesses are caught on the cabinet/carrier framework.
!
10. Remove the carrier by sliding it out the front of the cabinet.
555-233-115
NOTE:
Note the position of the TDM/LAN cables before disconnecting them.
Figure
Figure
Figure
Figure
CAUTION:
Cables and wiring harnesses can be damaged if they catch on the
framework and if too much pressure is applied in removing the carrier.
6-8).
6-8).
6-9). These straps are reconnected to the
6-9). These straps are reconnected to the
Issue 5 October 2002
6-17