Avaya DEFINITY Server R Manual page 388

Adding New Carriers and EPN Cabinets
Install Circuit Packs
1. Install the new circuit packs into the new carrier. Use the decal and the
upgrade configuration document (provided with the equipment) as a guide.
2. Install circuit pack blanks in slots not equipped with circuit packs.
Interconnect Port Networks
1. Behind the cabinet containing the new switch node carrier (see
for critical reliability):
a. Connect the metallic intracarrier cable between slots 1E01 and
b. Connect the metallic intracarrier cable between slots 1D01 and
2. Behind switch node carrier D or E of PPN cabinet 1 (See
a. For each EPN, install one 9823-type lightwave transceiver on the
b. Connect 1 end of each fiber optic cable to each lightwave
c. Carefully attach the fiber optic cables (with cable ties) to the wall of
3. Behind control carrier A of each EPN cabinet:
a. Install a lightwave transceiver on the cable connector on slot A01.
b. Connect the other end of the fiber optic cable to the lightwave
c. Carefully attach the fiber optic cable (with cable ties) to the wall of
d. Coil up the surplus length of fiber optic cable, and carefully attach
4. If high or critical reliability, behind switch node carrier D of PPN cabinet 1
(See
a. For each EPN, install a lightwave transceiver on the following order
b. Connect 1 end of each fiber optic cable to each lightwave
c. Carefully attach the fiber optic cables (with cable ties) to the wall of
6-68
Issue 5 October 2002
1E02.
1D02.
following order of D slots: 1D20, 1D03, 1D19, 1D04, 1D18, 1D05,
and so forth, or E slots: 1E20, 1E03, 1E19, 1E04, 1E18, 1E05, and
so forth
transceiver, just installed.
the cable tray at the built-in cable-tie positions.
transceiver, just installed (A01).
the cable tray at the built-in cable-tie positions.
the coil to the wall of the cable tray.
Figure 6-37):
of slots: 1D20, 1D03, 1D19, 1D04, 1D18, 1D05, and so forth.
transceiver, just installed.
the cable tray at the built-in cable-tie positions.
Figure 6-37
Figure 6-37):
555-233-115