Avaya DEFINITY Server R Manual page 480

Adding or Removing Cabinet Hardware
6. Type in the following information for the TN2302AP IP Media Processor
and TN799B/C C-LAN:
— Set Slot field to UUCSS, where UUCSS is the cabinet, carrier, and
— The Code and SFX fields are automatically populated with
— In the Node Name field type the same node name entered on the
— In the Subnet Mask field use the default setting unless you are
— In the Gateway Address field use the address you are given or
— Set the Net Region field to 1 unless you are given a different
— Set the Enable Eth Pt field to y
7. Press
Refer to the Administration for Network Connectivity for Avaya MultiVantage
Software for more information on these administration steps and for the steps to
administer IP Softphones and H.323 trunks.
NOTE:
The administration of the TN2302AP is the same as that for the TN802B.
Test the External Connection to the LAN
To test the external IP connections, ping the C-LAN or IP Media Processor server
and ping a known computer connected to your network. If everything is configured
correctly, the Result column on the Ping Results screen reads pass. If it reads
abort, verify the IP-address information and check the connectivity, including the
cabling.
1. Type ping ip-address nnn.nnn.nnn.nnn board UUCSS and press
The variable nnn.nnn.nnn.nnn is the IP address of the TN2302AP IP
Media Processor and UUCSS is the cabinet, carrier, and slot of the
TN2302AP IP Media Processor.
7-64
Issue 5 October 2002
NOTE:
Enable the Ethernet port last, after you have filled in the information
in the other fields.
slot.
TN799B/C and TN2302AP.
Node Name screen.
given a different subnet mask.
leave blank.
number.
to save the information and effect the new settings.
Enter
Enter.
555-233-115