Avaya DEFINITY Server R Manual page 413

Remove an EPN Cabinet from an Existing System
3. Scroll to screen 2.
a. Remove the DS1 Converter Facilities information. In the Facility
b. The Bit Rate
c. The idle code in the Idle Code MSB (1) . . . . LSB (8):
d. The data in the Line Coding: field must remain administered.
4. For a T1 site, proceed to
''E1 Installations
T1 Installations Only
1. The Framing Mode: field is display only.
2. The DS1CONV-1 Line Compensation: and the DS1CONV-2 Line
Compensation: fields are display only.
3. Remove the Facility Circuit ID information from the facilities being
unadministered, if used. Press
4. A display similar to the following appears after the procedure is completed:
RESET PORT-NETWORK 2 LEVEL 2 (COLD) PERFORMED.
E1 Installations Only
1. The CRC? field must remain administered.
2. The Line Termination: field is display only.
3. Remove the Facility Circuit ID information from facilities being
unadministered, if used. Press
4. A display similar to the following appears after the procedure is completed:
RESET PORT-NETWORK 2 LEVEL 2 (COLD) PERFORMED.
All Installations
1. When the system reset is finished, type status port-network 2 and press
Enter
"up" and that the Service State is "in."
2. A Span LED, on the front of the DS1 Converter circuit pack, must be off for
each inactive facility administered. For example, if Facility A and Facility B
are unadministered, then the top 2 Span LEDs on the circuit pack must be
off. If the yellow LEDs are on, then problems were encountered during the
unadministration of hardware. Span LEDs associated with administered
facilities (C and D, in this example) should be on.
555-233-115
Installed? field, type no for all facilities (A, B, C, and D) to be
removed.
:
field must remain administered.
field must remain administered.
''T1 Installations
Only''.
. The Port Network Status screen appears. Verify that PNC Active is
Only''. For an E1 site, proceed to
.
Enter
.
Enter
Issue 5 October 2002
6-93