Avaya DEFINITY Server R Manual page 427

Downloading Firmware to Port Circuit Packs
d. Enter display data-module ID to obtain the link's number.
e. Enter status link link_number to check the link's status and obtain
3. If this is a remote download, continue with
7-18.
If not, continue with the following section.
Self-Download
During this procedure, you will use an FTP client to copy the new firmware image
file to a circuit pack. Then you will copy the new image to the FLASH memory on
the pack. This procedure updates only a single circuit pack and applies to these
circuit packs:
TN799DP Control LAN (C-LAN)
TN2501AP Voice Announcements over LAN (VAL)
NOTE:
If you have any trouble with this procedure, refer to
firmware downloads'' on page
Set up circuit pack's file system
Before you can upload staged files to the source circuit pack, you must set up a
file system on the circuit pack to accept the files.
1. Log into the switch using a superuser or services login and password.
2. Enter enable filesystem board UUCSS login ftplogin ftppassword [size
actual_size], where:
Later, you will use this same ftplogin and ftppassword in the following
section,
555-233-115
the source IP address.
ftplogin is any temporary login ID for this FTP session (for example,
denver).
ftppassword is any ≥ 7-character temporary password for this FTP
session (for example, broncos).
''FTP the new firmware image
NOTE:
The optional size actual_size qualifier only works with TN799C
(C-LAN). It allows you to specify a smaller file-system size than the
default 1-MB block (maximum) allocated.
If the source circuit pack has insufficient memory, delete old files
(remove file board UUCSS filename), or wait until there is less
traffic on the board.
''Remote download'' on page
''Troubleshooting
7-25.
file''.
Issue 5 October 2002
7-11