Avaya DEFINITY Server R Manual page 442

Adding or Removing Cabinet Hardware
2. The example in
successful test of the firmware download circuitry.
If the test does not pass, refer to the Error Log Entries and Test to Clear
Values section of the FW-DWNLD maintenance object in the maintenance
book.
Backing out of firmware download
To revert back to the old firmware image file on TN799DP (C-LAN) or TN2501AP
(VAL) only:
1. At the SAT, enter get boot-image UUCSS and press
status of the firmware images on the target circuit pack.
The Display Firmware Image(s) report
get boot-image 1C07
Image 1
Board Type: TN2501
FW Vintage: 02
HW Signature: 02
Suffix: A
Date: 03/02/02
Timestamp: 10:30:50
CRC Checksum: Good
Active Image: Yes
Reboot Image: Yes
Screen 7-10. Display Firmware Image(s) screen
a. Check Image 1 and Image 2 to see where the active image resides.
b. Check the date and time stamps to determine whether to revert
In the following example, we are reverting back to Image 2, because it has
the older date and time stamp.
2. At the SAT, type set boot-image board UUCSS image 1 | 2 and press
.
Enter
Example: set boot-image board 1C07 image 2
The system responds with Command Successfully Completed.
7-26
Issue 5 October 2002
Screen 7-9
DISPLAY FIRMWARE IMAGE(S)
Image 2
TN2501
01
02
A
03/02/01
12:42:18
Good
No
No
back to Image 1 or Image 2.
NOTE:
In most cases, the image with the more recent date and time stamp is
the new firmware image file.
shows PASS in the Result field, indicating a
(Screen 7-10) appears.
to check the
Enter
555-233-115