Avaya DEFINITY Server R Manual page 347

Add a Control Carrier (Add Duplication)
Install the License File
NOTE:
After adding a duplicate control carrier, you must use the following
procedure to install the License File.
New, duplicated G3r systems only
1. Retrieve the RFA License File with both serial numbers from the RFA
Application.
2. Type set time and press
Ensure that the system date and time are set correctly.
3. Use one of these installation methods:
Installation (direct connection)
If you have a direct connection between the RFA and the switch:
a. Go to the RFA website, and, following the instructions in the "Deliver
b. If the system has IP endpoints registered, and you unplugged the
c. Continue with Step 4 below.
Installation (no direct connection)
If you do not have a direct connection between RFA and the switch:
a. Go to the RFA website, and, following the instructions in the "Deliver
b. Open the License Installation Tool (LIT) application at your
c. Use the LIT instructions to add a switch connection profile to the
d. Use the LIT instructions to install the License File on the switch.
e. Continue with Step 4.
555-233-115
Enter
''Installation (direct connection)''
''Installation (no direct connection)''
to G3r/G3si/G3csi" chapter of the RFA Job Aid, deliver the License
File.
NOTE:
This procedure sends the License File to the switch and installs it.
Ethernet cable from the TN799 (C-LAN) circuit pack, replug the
cable.
This re-registers the IP endpoints.
to G3r/G3si/G3csi" chapter of the RFA Job Aid, deliver the License
File to your laptop/PC.
laptop/PC.
tool.
.
Issue 5 October 2002
6-27