Avaya DEFINITY Server R Manual page 485

Add IP Solutions
Replace the Cables
1. Disconnect the network cable from the Ethernet connection.
2. Turn off the modem and unplug it from the AC outlet. It is not needed for
the TN2302AP.
3. Disconnect the modem's RS232 port from the H600-512 external cable
assembly.
From the rear of the cabinet:
4. Disconnect the amphenol connector on the external cable assembly from
the backplane connector corresponding to the TN802B circuit pack.
5. Connect the amphenol connector on the TN2302AP Amphenol adapter to
the backplane connector corresponding to slot selected for the TN2302AP
circuit pack.
6. Connect the network cable to the Ethernet connector on the TN2302AP
Amphenol adapter.
Install the circuit packs
1. If replacing the TN799 circuit pack, install the TN799B/C circuit pack in the
slot vacated by the TN799 circuit pack.
2. For convenience install the TN2302AP circuit pack in the rightmost slot
vacated by the TN802B and where the adapter is connected to the
corresponding backplane connector. The other 2 slots are now available for
other circuit packs.
When you plug in the TN2302AP IP Media Processor, the circuit pack starts to
boot. The RED LED stays on until an IP address is assigned to the circuit pack.
3. Type list configuration all and press
recognizes the TN2302AP circuit packs.
Administration Steps
1. Administer the TN799B/C C-LAN, if necessary. Refer to the Administration
for Network Connectivity for Avaya MultiVantage Software.
2. Administer the IP Media Processor, which is usually done remotely. Call
your service representative to start the process.
555-233-115
NOTE:
The TN802 circuit pack occupied 3 slots, and the cable was
connected to the rightmost slot. For convenience use the same
rightmost slot vacated by the TN802B circuit pack for the TN2302AP
circuit pack. The other 2 slots are now available for other circuit
packs.
to verify that the system
Enter
Issue 5 October 2002
7-69