Avaya DEFINITY Server R Manual page 309

Interconnect Port Networks with Fiber Optic Cabling
2. Behind control carrier A of EPN cabinet 3:
3. Behind control carrier B of PPN cabinet 1:
4. Behind port carrier B of EPN cabinet 3:
5. Behind control carrier A of EPN cabinet 2:
6. Behind control carrier A of EPN cabinet 3:
555-233-115
Install a lightwave transceiver on the cable connector at slot 3A01.
Connect the other end of the fiber cable to the transceiver just
installed.
Carefully attach the fiber optic cable (with cable ties) to the wall of
the cable tray at the built-in cable tie positions.
At the top of the cabinet, coil up the surplus fiber optic cable and
attach it to the wall of the cable tray.
Install a lightwave transceiver on the cable connector at slot 1B02.
Connect a fiber optic cable to the transceiver just installed.
Carefully attach the fiber optic cable (with cable ties) to the wall of
the cable tray at the built-in cable tie positions.
Install a lightwave transceiver on cable connector at slot 3B02.
Connect the other end of the fiber optic cable to the lightwave
transceiver, just installed, at slot 3B02.
Carefully attach the fiber optic cable (with cable ties) to the wall of
the cable tray at the built-in cable tie positions.
At the top of the cabinet, coil up the surplus length of fiber optic
cable, and carefully attach the coil to the wall of the cable tray.
Install a lightwave transceiver on cable connector at slot 2A02.
Connect 1 end of the fiber optic cable to the lightwave transceiver,
just installed, at slot 2A02.
Carefully attach the fiber optic cable (with cable ties) to the wall of
the cable tray at the built-in cable tie positions.
Install a lightwave transceiver on cable connector at slot 3A02.
Connect the other end of the fiber optic cable to the lightwave
transceiver, just installed, at slot 3A02.
Carefully attach the fiber optic cable (with cable ties) to the wall of
the cable tray at the built-in cable tie positions.
At the top of the cabinet, coil the surplus fiber optic cable, and
carefully attach the coil to the wall of the cable tray.
Issue 5 October 2002
5-117