Interconnect Port Networks With Fiber Optic Cabling - Avaya DEFINITY Server R Manual

Upgrading R5si/R6si to an Avaya DEFINITY Server R
EPN running Avaya MultiVantage Software
Save Translations
1. Type save translation and press
disk. If the translations were corrupted during the upgrade, the following
error message displays when logging in:
!
Return Replaced Equipment
1. Return replaced equipment to Avaya according to the requirements
outlined in:
BCS/Material Logistics, MSL/Attended Stocking Locations
Methods and Procedures for Basic Material Returns
Interconnect Port Networks with Fiber
Optic Cabling
Follow the procedures for conceding all the port networks, depending on the type
of reliability:
Standard Reliability
High Reliability
Critical Reliability
Standard Reliability
After all fiber optic equipment is installed, refer to
Administration''.
NOTE:
Keep track of which fiber attaches to which connector on each lightwave
transceiver. Label every cable installed. This section provides figures
showing typical examples of these connections.
The connectors on the lightwave transceivers are labeled TX (transmit) or RX
(receive), while the fibers attaching to each connector are numbered either 1 or 2.
See Figure
4-40
Issue 5 October 2002
WARNING:
Translation corruption detected; call Avaya distributor immediately.
NOTE:
The save translation command cannot function if the translation
corruption message appears.
4-10.
to get upgraded translations onto
Enter
Appendix A, ''Fiber Link
555-233-115