Avaya DEFINITY Server R Manual page 179

Interconnect Port Networks with Fiber Optic Cabling
Two, 4, 6, or 8 pairs of wall-field cables (provided with the CSUs)
5, 10, or 15 dB attenuators (single-mode fiber only).
5-dB Attenuator
10-dB Attenuator
15-dB Attenuator
For a critical reliability system with 2 DS1 CONV-remoted EPNs, this arrangement
requires:
12 DS1 CONV circuit packs (TN1654)
12 DS1 CONV-to-EI cables (847245750 and/or 847245768)
12 H-600-348 cables
6, 12, 18, or 24 pairs of CSUs
6, 12, 18, or 24 pairs of wall-field cables (provided with CSUs)
5, 10, or 15 dB attenuators (single-mode fiber only).
5-dB Attenuator
10-dB Attenuator
15-dB Attenuator
For 1 or 2 Collocated Expansion Port Networks. 1.Behind port carrier C of the
multicarrier PPN. See
a. Install a lightwave transceiver on the connector at slot 1C02.
b. Connect 1 end of the appropriate fiber optic cable to the lightwave
c. Route the fiber optic cable from the lightwave transceiver to the
d. Carefully attach the fiber optic cable (with cable ties) to the wall of
555-233-115
106060718
106060734
106061021
106060718
106060734
106061021
Figure 4-15
NOTE:
Attenuators may be required for single mode fiber using a
300A Lightwave Transceiver
transceiver just installed.
cabinet's cable tray and down, out of the cabinet, to the EPN stack.
the cable tray at the built-in cable tie positions.
and Figure 4-16:
Issue 5 October 2002
4-53