Avaya DEFINITY Server R Manual page 183

Interconnect Port Networks with Fiber Optic Cabling
Switch-Connected Port Networks
For 1 to 15 Standard Reliability EPNs.
1. Behind the PPN cabinet. See
a. Install a lightwave transceiver on cable connector at slot 1E02.
b. Install a lightwave transceiver on cable connector at slot 1B02.
c. Connect 1 end of the metallic intercarrier cable to the lightwave
d. Route the intercarrier cable from the lightwave transceiver to the
e. Connect the other end of the intercarrier cable to the lightwave
f. Attach the intercarrier cable (with cable ties) to the wall of the cable
2. Behind switch node carrier E of PPN cabinet 1. See
a. For each EPN, install 1 lightwave transceiver on a cable connector
b. Connect 1 end of each fiber optic cable to each lightwave
c. Carefully attach the fiber optic cables (with cable ties) to the wall of
3. Behind control cabinet A of each single-carrier EPN:
a. Install a lightwave transceiver on cable connector at slot A01.
b. Connect the other end of the fiber optic cable to the lightwave
c. Carefully attach the fiber optic cable (with cable ties) to the rear
d. Coil up the surplus length of fiber optic cable, and place the coil
555-233-115
transceiver at slot 1E02.
cabinet cable tray and upward to carrier "B."
transceiver at slot 1B02.
tray at the built-in cable tie positions.
with the following order of slots: 1E20, 1E03, 1E19, 1E04, 1E18,
1E05, and so forth.
transceiver, just installed.
the cable tray at the built-in cable tie positions.
transceiver, just installed, at slot A01.
covers of the EPN stack.
either in the cable manager or on the bottom shelf (holding the
power supply) of the PPN cabinet.
Figure 4-17:
Issue 5 October 2002
Figure 4-17:
4-57