Boot The System; Install The License File - Avaya DEFINITY Server R Manual

Upgrading a Multicarrier G2 Universal Module to Avaya
DEFINITY Server R EPN running Avaya MultiVantage
Software

Boot the System

1. Connect the PC to the "TERMINAL" connector behind PPN control carrier
"A," or install the G3-MA according to the "Set Up G3-MA" chapter of
DEFINITY Communications System Generic 3 Management Applications
—
Operations.
2. Insert the translation card in the TN794 faceplate.
3. At the EPN power distribution unit, set the main circuit breaker to ON.
4. At the PPN power distribution unit, set the main circuit breaker to ON.
5. The system performs the reset level 4 rebooting process, loading default
system translations from the translation card. This takes 8 to 11 minutes.
6. To use Access Security Gateway (ASG), see
Security

Install the License File

Pre-installation
1. Type save translation and press
After the translations have been copied (about 10 minutes), the system
returns an error code, which must be a zero; otherwise, the translations are
not copied.
2. Type reset system 3 and press
Wait until the system has completely reset before continuing.
3. If the system has IP endpoints registered, unplug the Ethernet cable from
the TN799 (C-LAN) circuit pack.
This disconnects (unregisters) all IP endpoints.
4. Type set time and press
Ensure that the system date and time are set correctly.
Installation (direct connection)
If you have a direct connection between the RFA and the switch:
1. Go to the RFA website, and, following the instructions in the "Deliver to
G3r/G3si/G3csi" chapter of the RFA Job Aid, deliver the License File.
2. If the system has IP endpoints registered, and you unplugged the Ethernet
cable from the TN799 (C-LAN) circuit pack, replug the cable.
This re-registers the IP endpoints.
5-30
Issue 5 October 2002
Gateway''.
Enter
NOTE:
This procedure sends the License File to the switch and installs it.
Appendix C, ''Access
.
Enter
.
Enter
.
555-233-115