Avaya DEFINITY Server R Manual page 410

Adding New Carriers and EPN Cabinets
3. Type change fiber link and press
screen appears. Each of the fiber links is identified by a fiber number.
a. The Is one endpoint remoted via DS1 Converter
b. Remove the location of the TN570 and the TN574 or TN1654 circuit
4. Scroll to screen 2.
a. Type no, as applicable, in each Facility Installed? field (A,
b. The Bit Rate: field must remain administered if other fiber
c. The idle code in the Idle Code MSB (1) . . . . LSB (8):
d. The Line Coding: field must remain administered.
5. For a T1 site, proceed to
''E1 Installations
T1 Installations Only
1. The Framing Mode: field is display only.
2. The DS1CONV-1 Line Compensation: and the DS1CONV-2 Line
Compensation: fields are display only.
3. Remove the Facility Circuit ID: from the facilities being
unadministered, if used. Press
4. A display similar to the following appears after the procedure is completed:
RESET PORT-NETWORK 2 LEVEL 2 (COLD) PERFORMED.
E1 Installations Only
1. The CRC? field must remain administered.
2. The Line Termination: field is display only.
3. Remove the Facility Circuit ID information from the facilities being
unadministered, if used. Press
4. A display similar to the following appears after the procedure is completed:
RESET PORT-NETWORK 2 LEVEL 2 (COLD) PERFORMED.
6-90
Issue 5 October 2002
complex? field must remain administered.
pack for both ENDPOINT-1 and ENDPOINT-2.
B, C, and D).
connections associated with the facility will remain.
field must remain administered.
''T1 Installations
Only''.
. The Fiber Link Administration
Enter
Only''. For an E1 site, proceed to
.
Enter
.
Enter
555-233-115