Avaya DEFINITY Server R Manual page 501

Add IP Solutions
Connect the Monitor, Keyboard, and Mouse
NOTE:
Only make these connections if administered locally. Not necessary if
administered remotely.
You must connect these before inserting the TN802B IP Interface.
1. Attach a VGA monitor to the VGA connector of the TN802B IP Interface
external cable assembly.
2. Attach the keyboard to the KEYBOARD connector of the external cable
assembly.
3. Attach the mouse to the MOUSE connector of the external cable assembly.
4. Plug the monitor into an AC power receptacle and turn it on.
Connect the Ethernet
1. Connect the network cable to the ETHERNET connector on the TN802B
external cable assembly.
NOTE:
You need a CAT5 or better cable for 100-Mbyte operation.
Install the Circuit Pack
!
CAUTION:
When adding or replacing any hardware, be sure to ground yourself against
electrostatic discharge (ESD) by wearing a grounded wrist strap.
NOTE:
The TN802B IP Interface is hot-swappable, so you do not need to power
down the carrier to install it.
If you need to remove the TN802B IP Interface from the carrier at a later
time, shut down Windows NT first by pressing the recessed reset button on
the faceplate (see
shows a flashing MSHUT *. When the flashing stops and the asterisk
disappears (about 2 min), it is safe to remove the circuit pack.
555-233-115
Figure 7-15) of the TN802B IP Interface until the LCD
Issue 5 October 2002
7-85