Avaya DEFINITY Server R Manual page 492

Adding or Removing Cabinet Hardware
Figure Notes
1. LCD display
2. Reset button (recessed)
3. Red board status LED
Figure 7-11. TN802B IP Interface faceplate
NOTE:
If replacing the existing TN799 circuit pack, remove it first and replace it with
the new one.
1. Insert the TN799B circuit pack into the port slot identified earlier.
7-76
Issue 5 October 2002
fpdfmapd KLC 030899
NOTE:
To properly seat the circuit pack, push firmly on the front of the
faceplate until the latch reaches the bottom rail of the carrier. Then
close the latch until it is fully engaged.
1
2
3
4
5
4. PCMCIA card slot
5. Yellow PCMCIA disk-in-use LED
555-233-115