Avaya DEFINITY Server R Manual page 482

Adding or Removing Cabinet Hardware
Remove the Circuit Packs
!
CAUTION:
When adding or replacing any hardware, be sure to ground yourself against
electrostatic discharge (ESD) by wearing a grounded wrist strap.
NOTE:
The TN799B/C, TN802, and TN2302AP circuit packs are hot-swappable, so
you do not need to power down the carrier to remove or install them.
1. Press the recessed Reset button on the TN802 circuit pack until MSHUT*
starts flashing on the LCD. When MSHUT* is in a steady state, it is safe to
remove the circuit pack.
2. Remove the TN799 and TN802 circuit packs.
Replace the Cables
1. Disconnect the network cable from the Ethernet connection.
2. If using a monitor, keyboard, and mouse:
a. Turn off the monitor and unplug it from the AC outlet.
b. Disconnect the monitor, keyboard, and mouse from the H600-512
3. Turn off the modem and unplug it from the AC outlet.
4. Disconnect the modem's RS232 port from the H600-512 external cable
assembly.
From the rear of the cabinet:
5. Disconnect the amphenol connector on the existing external cable
assembly from the backplane connector corresponding to the TN802 circuit
pack.
6. Connect the amphenol connector of the TN2302AP Amphenol adapter to
the backplane connector corresponding to the slot selected for the
TN2302AP circuit pack.
7. Connect the network cable to the Ethernet connector on the TN2302AP
Amphenol adapter.
7-66
Issue 5 October 2002
external cable assembly.
NOTE:
The TN802 occupied 3 slots, and the cable was connected to the
rightmost backplane slot. For convenience use the same rightmost
slot vacated by the TN802 circuit pack for the TN2302AP circuit pack.
555-233-115