Rep 3.4.1 Exposure Lamp - Xerox DocuColor 12/DCCS50 Service Manual

Figure 1 Removing the Carriage Motor
Installation
1. Reinstall the parts in the reverse order of disassembly.
Reissue
DocuColor 12/DCCS50

REP 3.4.1 Exposure Lamp

Parts List on PL 3.4
Removal
Turn power off and disconnect the power plug.
Avoid touching the exposure lamp with your bare hands during removal or installation. Oil from
your hands will contaminate the surface of the lamp.
1. Open the Platen Cover or DADF.
2. Remove the Platen Glass (REP
3. Move the Full Rate Carriage to the frame notch.
4. Remove the Exposure Lamp (Figure
1. Disconnect the connector.
2. Remove the screw.
3. Remove the Exposure Lamp.
Figure 1 Removing the Exposure Lamp
Installation
1. Reinstall the parts in the reverse order of disassembly.
1/05
4-61
WARNING
CAUTION
3.1.1).
1).
Repairs and Adjustments
REP 3.3.2, REP 3.4.1