Subaru Legacy 2004 Service Manual page 4162

• The number of poles or pins, presence of a lock are indicated in the sketch of each connector. In the
sketch, the highest pole number refers to the number of poles which the connector has. For example, the
sketch of the connector shown in figure indicates the connector has 9 poles.
Connector used in vehicle
• When one set of connectors is viewed from the
front side, the pole numbers of one connector are
symmetrical to those of the other. When these two
connectors are connected as a unit, the poles
which have the same number are joined.
1
2
3
6
5
4
• WIRING DIAGRAM:
The connectors are numbered along with the num-
ber of poles, external colors, and mating connec-
tions in the accompanying list.
• The sketch of each connector in the wiring dia-
gram usually shows the (A) side of the connector.
The relationship between the wire color, terminal
number and connector is described in the figure.
Basic Diagnostic Procedure
Sketch
Double frames
Indicates a lock
is included.
4 3 2 1
9 8
7 6 5
Indicates the number of poles.
Indicates a lock is included.
1 2 4
3
5 6 9
7 8
Single frame
1
2
3
6 5
4
WI-00107
WI-5
Connector shown in wiring diagram
Symbol
NOTE:
A wire which runs in one direction from a connector
terminal sometimes may have a different color from
that which runs in the other direction from that ter-
minal.
BR
RW
F4
Wire color :
BR (No. 1 terminal)
RW (No. 3 terminal)
WIRING SYSTEM
Number of poles
Numbered in order from upper
right to lower left.
Numbered in order from upper
left to lower right
i2
1
3 1 2
3 4
(A)
i2
WI-00108
WI-00102