Combination Base Switch Assembly - Subaru Legacy 2003 Service Manual

11.Combination Base Switch
Assembly
A: REMOVAL
1. WITHOUT VDC MODEL
1) Remove driver's airbag module. <Ref. to AB-12,
REMOVAL, Driver's Airbag Module.>
2) Remove steering wheel. <Ref. to PS-24, RE-
MOVAL, Steering Wheel.>
3) Remove steering column cover.
4) Remove combination switch. <Ref. to LI-11, RE-
MOVAL, Combination Switch (Light).> <Ref. to
WW-8, REMOVAL, Combination Switch (Wiper).>
5) Loosen 4 screws and remove roll connector.
6) Loosen 3 screws.
7) Disconnect connector and remove combination
base switch assembly.
2. WITH VDC MODEL
1) Remove driver's airbag module. <Ref. to AB-12,
REMOVAL, Driver's Airbag Module.>
2) Remove steering wheel. <Ref. to PS-24, RE-
MOVAL, Steering Wheel.>
3) Remove steering column cover.
4) Remove combination switch. <Ref. to LI-11, RE-
MOVAL, Combination Switch (Light).> <Ref. to
WW-8, REMOVAL, Combination Switch (Wiper).>

COMBINATION BASE SWITCH ASSEMBLY

LI-00181
5) Loosen 3 screws.
6) Disconnect connector and remove combination
base switch assembly.
CAUTION:
In case of model with VDC, do not separate roll
connector from combination base switch.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Align the attaching direction of roll connector
with steering wheel, before installation of steering
wheel.<Ref. to AB-19, ADJUSTMENT, Roll Con-
nector.>
C: INSPECTION
1. COMBINATION BASE SWITCH ASSEM-
BLY
Perform inspection for the following items and re-
place with a new one, if any damage is found.
• Crack or deformation of combination base switch
assembly or roll connector
CAUTION:
In case of model with VDC, do not separate roll
connector from combination base switch.
LI-13
LIGHTING SYSTEM
LI-00182