Schlage PIB300 User Manual page 749

Problem
The PIM400-485
reports false tamper
detections to the
Access Control Panel.
The PIM400-485 does
not communicate with
Wireless Access Point
Modules (WAPMs)
14 • Schlage • PIM400-485 user guide
Possible cause
An intense light source
may cause interference
with the optical receiver
(version 2 model only)
when the enclosure cover is
removed.
Improper wiring may cause
interference with the optical
transmitter and optical
receiver (version 2 model
only).
Improper wiring may cause
false tamper detection at
the ACP (version 1 model).
The Antenna Module may
not be properly installed.
Wiring may cause
interference with the
internal antenna on the
Antenna Module.
The PIM400-485 may not
be linked to the Wireless
Access Point Module
(WAPM).
Solution
Move the PIM400-485 (version 2
model only) away from the intense
light source and ensure that the
enclosure cover is installed.
Refer to Wire routing on page 8
for proper wire routing instructions.
Ensure that the Antenna Module is
installed and properly seated.
Check to ensure that wiring is
properly routed in the PIM400-485
enclosure and the area around
the internal antenna is clear of any
wire. See Wire routing on page
8 for more information.
Link the PIM400-485 to the
Wireless Access Point Module.
See Link mode on page 12 for
more information. Also refer to the
Wireless Access Point Module's
User Guide for Link instructions.