Schlage PIB300 User Manual page 263

Set Address
The Set Address command allows a unique address to be set for each
HandPunch in a network. For proper operation, each HandPunch in the
network must have a unique address. All units may use any address from 0 to
254. All units are sent with the address set to 1.
Set ID Length
The Set ID Length command allows you to reduce the number of keystrokes
required to enter the ID number by eliminating the use of the ENTER key
to complete an ID number entry. Once the ID Length is set, the HandPunch
will automatically accept an ID number entry once the correct number of
characters have been entered.
Set ID Length does not apply when ID entry is made from a card reader. Once
the ID Length is set, the T & A Mode Set command appears, allowing you
to configure the HandPunch to prepare punch data for time and attendance
software.
The Set Serial command allows you to set communication parameters
Set Serial
depending upon the communication method for which the HandPunch has
been configured. Different configuration parameters are entered based on if
the unit is configured for a direct-connection or a modem connection, or if the
unit is configured for Ethernet communication.
The unit defaults to the RS-422 communication mode unless a modem or
Ethernet module has been installed. The unit defaults to 9600 bps which is
suitable for most communication applications.
If an Ethernet module has been installed, the IP Address and Gateway and
Subnet Mask must be set. The host bits should be left at 0, if communicating
across a LAN.
Set Output
The Set Output Mode command allows you to set how the output relays
Mode
operate. The relays should be set based on the HandPunch application.
Set the HandPunch to Lock/Auxiliary Relay mode if the unit is acting as door
controller (this is the factory default setting).
Set the HandPunch to Card Reader Emulation mode if the unit is outputting to
an access control panel.
Upgrade
This Upgrade Menu is where the HandPunch code gets input to allow for a
Memory Upgrade.
HandPunch 3000/4000 Manual
59