Activity Messages; Command Menus In The Reader - Schlage PIB300 User Manual

Monitoring Ongoing Activity

Activity Messages

Command
Menus in the
Reader
Activity
Messages
116
You see activity messages in the Activity window. You can limit the activity in
a custom activity view or in an activity report by checking the corresponding
messages on the Messages tab in the filter/report design (see page 112). And you
can control which messages cause alarms using the Alarms tab in the system
settings (see page 25).
We have explained the messages in more detail here.
Readers have built-in menus that let you change the settings in the reader.
Some of the messages below can only occur if you make changes through
these menus on the actual readers; you should not typically see these
messages. Except for initially setting up the reader to communicate with
HandNet, for recalibrating the reader, and for enrolling a user from the reader,
you should NOT make changes to the reader through the reader command
menus; you should control all other reader settings from within HandNet. See
the HandKey manual for more about the reader menus.
Access Denied: Someone repeatedly entered a valid ID at a reader, and each
time the reader did NOT recognize the user's hand (at the reader, the user
will see the message ID Refused). The number of times that a user can
try before getting this message depends on the Number of Tries entry on
the Settings tab in the Reader Properties; see page 47. If access is denied
for a user, the reader will not accept that ID again until another user has
successfully gained access at that reader.
Access Profiles Changed: Someone has changed one or more access
profiles. During initial setup, this is a normal message. If you were not
expecting access profiles to change, this could be an indication that
someone was trying to give inappropriate access.
Access Refused, Time Zone: A valid ID was entered at a reader, but the user
is not authorized to have access during the hours or days of the week
based on the time zone associated with the reader in the access profile.
Activated Limited Access User: A user was set up with access for a limited
date/time range. The computer's date and time matched the date/time the
user was scheduled to start having access, so HandNet made the user
active and sent the user's information to each appropriate reader so the
user could can access; see page 93 for more about limited access.
Activity Archived: The operator used the Archive option on the File menu; (see
page 113 for more on archiving past activity).
Alarm Acknowledged: An alarm occurred, and an operator went to the Alarm
Properties screen and clicked one of the acknowledge buttons (following
the message on the activity or alarm list, you will see :ACK followed by
the name of the operator who acknowledged the alarm and when it was
acknowledged); see page 103 for more on acknowledging alarms.
Amnesty Punch Granted: You should not see this message.
Authority Level Changed: A user's authority level was changed from the
reader's command menu (typically you would change a user's authority