Schlage PIB300 User Manual page 296

Appendix C - Old Board Configuration
End of Line
Termination helps to ensure clean data signals are transmitted through the
Termination network wiring. Termination is applied to the end-of-line (EOL) HandPunch
in the network daisy-chain. The factory default setting is for EOL termination
to be disabled – switches 1 and 2 OFF. Refer to "Figure 13-15" on page 91 for
switch ON/OFF positioning.
•
•
EOL Termination must be enabled for:
•
•
•
EOL Termination must be disabled for:
•
•
Communication Method
The communication method dip switch is set ON for factory testing purposes.
The factory default setting and for standard operation, switch 3 must be OFF.
•
Erasing HandPunch Memory
The erase memory function can perform either or both of the following:
•
•
The factory default setting (and normal operation setting) is set for switches 4
and 5 to be OFF, retaining memory.
If the HandPunch is equipped with the battery backup option, remove shunt
NOTE
J7 in front of the DIP switch array (see "Figure 13-3" on page 78) before
proceeding. Replace shunt J7 after completion of the following steps.
92
To enable EOL termination at a HandPunch, both switches 1 and 2 must
be ON.
To disable EOL termination at a HandPunch, both switches 1 and 2 must
be OFF.
A single HandPunch terminal installation.
In a HandPunch Direct-Connect network – the last HandPunch in the
daisy-chain (the one farthest from the host computer).
In a Modem/HandPunch to PC network the HandPunch terminal with the
Ethernet option (for communication with the host computer) in the daisy-
chain.
All HandPunches in the network not identified in teh previous section.
In an Ethernet/HandPunch to PC network the HandPunch terminal with
the Ethernet option (for communication with the host computer) in the
daisy-chain.
Switch 3 must always be OFF.
Erase a HandPunch's configuration data.
Erase a HandPunch's user database, transaction buffer, and menus (and
messages on the HandPunch 4000).