Schlage PIB300 User Manual page 1072

1000 User Manual Programming Guide
Credential Functions
Credential Functions
Credential Functions
All keypad products have 2 factory default codes detailed below.
When a Programming Code plus * is entered or a Programming credential is presented, the LEDs
alternately flash several times indicating the lock is in a Programming Mode. If more than 30 seconds
pass in between programming entries, the lock returns to a normal operational state.
For security reasons, the factory default codes must be deleted. To automatically delete all factory
default codes, change the default Programming Code (see procedure on page 2 or 3). For locks
without keypads, see: To Create a Programming Credential: on page 4 .
When enetering codes and a wrong button is pressed, press the * button to clear the keypad. Then
re-enter the entire code. The keypad will clear itself if no button is pressed within approximately 10
seconds.
If any keypad buttons are pressed 20 times in succession, without a valid code being entered, the key-
pad will shutdown for 30 seconds.
57001-C Page 6 of 8 08-2009