Schlage PIB300 User Manual page 863

Doors
HandKey II
1. Enter the reader address into the Reader Address box.
Î The address must be between 0 and 254. The address 170 is reserved and cannot be used. See the HandKey II
documentation for information on locating the reader address.
2. Select the connection type from the Connection Type box.
Î Check with your system administrator or see the HandKey II documentation for information on determining the connection
type.
3. Enter the IP address into the TCP/IP Address box or select the serial port from the Serial Port drop-down box
Î Check with your system administrator or see the HandKey II documentation for information on determining the IP address
or serial port.
4. Click Test Connection.
5. If the Connection Successful box appears, click OK. All options were configured correctly and the reader and the system are
communicating properly.
6. If the No Reader Found box appears, click OK and go back to step 6 and check all options. The reader cannot be located
using the settings provided.
7. Click Configure Setup to configure the reader setup.
8. Assign AutoUnlocks to the door, if desired.
Î AutoUnlocks can be assigned to a door at any time.
9. Assign holidays to the door, if desired.
Î Holidays can be assigned to a door at any time.
Mechanical
The Mechanical Lock Properties information is completely optional. The Schlage SCHLAGE EXPRESS Software does not utilize
this information in anyway. This screen is used to record the mechanical key management information for your facility for those
locks/doors that are not controlled electronically or to record the mechanical key override information of electronic lock with
mechanical key override capability. To complete this information, you will need to work directly with your facility locksmith.
If you are unsure whether you should enter mechanical key information into Schlage SCHLAGE EXPRESS software, contact
technical support.
1. To add lock properties, click Properties.
BE367 Deadbolt Lock
1. Click to select/deselect the Enable Lock & Leave check box to enable/disable the Lock & Leave feature.
Î The Lock & Leave Feature is a feature that applies only to BE367 Deadbolts. When Lock and Leave is enabled, the
deadbolt can be re-locked from the outside of the door for a short period of time. By default, the Lock and Leave feature is
disabled.
2. After the Device type has been chosen and set up:
c. Click Save.
d. Click Close to return to the main window.
76 • Schlage • Schlage Express Software Manual