Schlage PIB300 User Manual page 1040

Beeper and LED Status During Verification
This is called a "lockout." Before the rejected ID number can be used again, another
employee or a supervisor must successfully verify at the HandPunch.
• If you enter your ID number, but do not place your hand on the platen, the HandPunch
will time-out in about 25 seconds. You can immediately end this time-out by pressing
the CLEAR key.
The HandPunch's beeper and LED status display also display hand verification
information. This information is defined in Table 19.
Beeper and LED Status During Verification
Operation
During Keypad 1 per Keystroke
Entry
After ID Entry –
After ID Entry 2
After Hand 1
Placement
After Hand 2
Placement
After Hand 1 Long
Placement Continuous
Beeps LED
–
–
–
Green
Red
Red
HandPunch 1000 Manual
Meaning
Keystroke Accepted
OK - Proceed
ID Number Not in
Database
ID Verified
ID Not Verified -
Try Again
ID Refused
55