Schlage PIB300 User Manual page 276

Appendix B - Board Configuration Differences
Appendix B
Noted Board Configuration Differences
Because of Schlage Biometrics' camera retrofit of the HandPunch some
changes have been made to the main PCB and they are listed as follows:
• Dipswitches have been removed
• The labeling of the terminal strips have changed. See "Figure 11-1" on
page 73.
• The configuration of the terminal strips have changed. See "Figure 11-2"
on page 74.
• Power has moved to the right side of the PCB.
• The RSS-232 RJ-45 receptacle has been replaced with a 4 pin Molex
• A 2 pin Molex connector (J5) has been added to the board, next to the
• The upgrading of the memory is now handled through software codes at
72
-comm lines are terminated.
-RS-485 is set by wiring jumpers.
-memory is reset with a push-button reset and user interface with
keypad and LCD.
connector on the left side of the PCB.
reset button, to supply power for the LEDs. This connector should never be
unplugged. unless a modem or Ethernet is added to the PCB.
the HandPunch. Contact Order Entry for memory upgrades.